1. AC GEN PWR - Up (Left & Right) [right, electrical control panel]
2. BOOST PUMPS WING - Up (Left & Right) [left, fuel system control panel]
3. BOOST PUMPS MAIN - Up (Left & Right) [left, fuel system control panel]
4. BATTERY PWR - Up [right, electrical control panel]
5. INVERTER STBY - Up [right, electrical control panel]
6. SIGNAL LIGHTS LAMP TEST (check all warning lights) [left, auxiliary lighting control panel]
7. FIRE DETECT BLEED AIR LEAK TEST (check engine fire light, bleed air leak light on caution annunciation panel) [left, auxiliary lighting control panel]
8. TEST IND (fuel display select set to INT. needles should be just above 4000lbs depending on fuel load. needles should drop to ~3000lbs +/-200. total should hit 6000lbs +/-200) [center, fuel panel]
9. FUEL DISPLAY SELECT - MAIN
10. OXYGEN SUPPLY (green wheel. check flow indicator is blinking) - Up [right, oxygen control panel]
11. OXY IND TEST (oxygen indicator test. check for warning when guage needle hits 0. note: do not let needle go below 0.) [right, oxygen control panel]
12. APU START - Up (check gauges & wait for 100% APU, 400C EGT. caution: abort if EGT exceedes 750C) [left, throttle quadrant]
13. CLOSE CANOPY [right, canopy control switch]
14. APU GEN PWR - up [right, electrical control panel]
15. EGI - Up (egi = embedded gps/ins) [right, avionics auxiliary panel (AMP)]
16. CDU - Up (cdu will flash briefly) [right, avionics auxiliary panel (AMP)]
17. CICU - Up (cicu = central interface control unit) [center, armament hud control panel (AHCP)]
18. JTRS - Up (jtrs = joint tactical radio system. will provide power to the situational awareness datalink (SADL)) [center, armament hud control panel (AHCP)]
19. IFFCC - Test (should see "engage preflight bit yes" on hud. (iffcc = integrated flight and fire control computer) [center, armament hud control panel (AHCP)]
20. LSKR4 - INS* (INS Align Page) [right, control display unit (CDU)]
21. LSKL1 - *ALIGN (this will go to main page. when fully align "INS NAV RDY" will begin blinking) [right, control display unit (CDU)]
22. Select Exit on HUD and press ENT button (twice) [center, up front controller]
23. IFFCC - Up (should see basic hud) [center, armament hud control panel (AHCP)]
24. Turn on MFCD's - (right click knobs twice for day, left click for night. they should show "DTS UPLOAD" after) [multi-function color display]
25. RIGHT MFCD OSB-10 - LOAD ALL (wait till all the astricks come back when DTS is loaded.)
26. LEFT MFCD OSB-15 - TAD (ta